Andonox KP-100 0,1 l
Red dyed MEKP used as an initiator in the curing of unsotereted resins.
This red dyed verson helps to control homogenous mixing and during curing discolouration will take place again.
Thosage: 1-3% to the weight of the resin.
Red dyed, mobile liquid, consisting of peroxides based on methylethylketone, essentially desensitised with phtalate plasticiser. This ketone peroxide is used as an initiator (radical source) in the curing of unsaturated polyester resins. Main application: curing of moulded, casted or winded glasfibre reinforced products at ambient temperature in combination with cobalt accelerators. This red dyed version helps to control homogenous mixing and during curing discolouration will take place again.
POLYESTER CURING: Curing agent for all UP resin types at ambient temperature in combination with cobalt accelerators. Standard dosage level: 1-3% as supplied, with 0.5-2% of a 1% cobalt solution. Suitable also for gelcoats with improved osmosis resistance and lowest porosity due to low water- and hydrogenperoxide content. "Pot life" (gel time of resin + peroxide + accelerator) relatively short, but may be prolonged by adding Inhibitors, such as tert.butyl catechol.
CURING PERFORMANCE: Moderate evolution of heat. Relatively long mould release time, moderate mould release factors. Temperatures below 20°C prolong curing times considerably, alternatively cobalt / amine accelerators should then be used.
PROCESSING METHODS: Particularly hand lay-up, spray lay-up, centrifugal casting, filament winding, casting of resins, and surface coatings (putties, fillers, gelcoats and topcoats).
Kiszerelés(ml)100 ml Weight122 g/pcs